HOW TO INSTALL STANDARD HORIZONTAL RAILING/ CONTINUED TREX TRANSCEND ®
Option
11
A fter top rail is fully installed, place aluminum baluster
11. S lide baluster spacer up and snap into top rail. Place optional top rail gaskets on each end of rail. TIP: Use soapy water on balusters when sliding baluster spacer up to avoid potential scratching of balusters. Attaching Post Caps and Installing Foot Blocks 12. Secure post caps with silicone or PVC adhesive (apply adhesive on the
adaptor strip into channel of top rail, ensuring that it’s fully seated into the channel. When rail lengths are non-standard, the adaptor strip will need to be cut 2 1/2" (64mm) shorter than the rail to allow clearance for the RBS's on each end.
12
9b
Placing Baluster Spacers 9b. Snap baluster spacer into bottom rail. Place inverted baluster spacer on top of first baluster spacer.
inside self-centering/ corner tabs). Attach foot block per foot block instructions.
NOTE: Clean up any excess adhesive before it dries.
10
Attaching Balusters 10. P lace baluster into
both baluster spacers, ensuring that balusters are fully seated into the channel. Working at a slight angle, maneuver balusters into top rail.
HOW TO INSTALL COCKTAIL RAILING TREX TRANSCEND
IMPORTANT NOTES: » ONLY use with 4 " x 4 " (102 mm x 102 mm) post and post sleeve. Cutting post and post sleeve ONLY applies to the Cocktail style railing. » Enhance cannot be used as top board for cocktail rail.
1. Installing Pressure-Treated Posts See instructions on page 225.
227 NOTE: Construction methods are always improving. Please refer to www.trex.com for the most up-to-date installation requirements.
Made with FlippingBook - Online Brochure Maker