HOW TO INSTALL BIRDSMOUTH HORIZONTAL RAILING TREX SELECT T-RAIL®
2
NOTES: » Use with 4x4 post sleeve only » Rails are not to be cut at angles, brackets accommodate railing that are cut flat when required. » Brackets must be installed on rails first. » For ease of bracket attachment place rail against stationary flat vertical surface along with bracket. PARTS
2. Mark rails and cut. Note rails do not need to be cut at an angle. If installing at full span railings may only require slight trim on each side for fit.
Birdsmouth T-Rail Bracket
3.
Attaching Foot Block to Bottom Rail and Adding Weep Holes See instructions on page 259.
Installing Brackets to Rail
Birdsmouth Bottom Rail Bracket
4
T-Rail
Measuring and Cutting Rails (when required)
1
4. Slide T-Rail Birdsmouth bracket onto T-Rail, ensuring that end of rail aligned is with center of bracket, and attach using three #8-18 x 1" self-drilling screws (provided).
5
Bottom Rail
1" (25.4 mm)
5. Invert the bottom rail (baluster holes facing down) and slide bottom Birdsmouth bracket onto bottom rail, ensuring that end of rail is aligned with center of bracket and bracket is positioned so the screw hole is facing up. Attach using one #8-18 x 1" self-drilling screw (provided).
1. Measure from corner-to-corner between posts ensuring baluster holes are at equal distance at each post location. Allow for a clearance of 1” for bracket placement.
Assembling Railing Section See instructions on page 260.
6.
262
Made with FlippingBook - Online Brochure Maker