HOW TO INSTALL SELECT® ALUMINUM RAIL HORIZONTAL PANEL/ CONTINUED
How to Measure and Cut Panel Rails (When REQUIRED)
1
4
1
3
2
4. Center foot block insert on underside of bottom rail, and install using one #10 x 3/4" screw. Push foot block shaft onto foot block insert.
1. Position panel between posts and ensure there is equal distance on each of the end balusters and posts. Allow 1-1/2" on each side of rails to allow for attach- ment to brackets.
5
5. Gently tap foot block
cap into foot block shaft.
KEY Mark Cut
KEY
2
Installing Panel to Brackets
6
3/8"
3/8"
2. Cut ends of both bottom and top rails 3/8" shorter on each side to allow for fit into brackets.
Installing Foot Block
3
6. Place panel in bottom and top brackets.
NOTE: THERE WILL BE A SMALL GAP BETWEEN THE BRACKETS AND THE RAILS.
7
7. Attach top panel rails to top brackets using three #10 x 3/4" self-drilling screws.
3. Turn panel upside down.
286 NOTE: Construction methods are always improving. Please refer to www.trex.com for the most up-to-date installation requirements.
Made with FlippingBook - Online Brochure Maker