HOW TO INSTALL ENHANCE STEEL RAIL STAIR PANEL/ CONTINUED
Marking and Cutting Stair Panel Rails (when re- quired)
Attaching Stair Panel to Stair Swivel Brackets
5
7
7. A ttach stair panel to swivel brackets using one #12 x 3/4" self-drilling screw (provided) on one side of stair bracket. Note: Brackets are designed to allow screw on either side, customer may choose based on preference.
5. M ark top and bottom rails where they align with the rear wall of the top and bottom brackets.
Attachment of Bracket Covers, Skirts, and Caps
KEY Mark Cut
KEY
13
6
9
1
8. G ently spread and then snap corresponding bracket covers over opening in upper and bottom rails.
1/16"
9. Attach provided post skirt to bottom of post.
6. R emove panel and place on flat surface (note stair panel can be "unracked" if necessary for ease of cutting). Extend marks to side of rails. Brackets are designed to allow for railing to be installed with a standard perpendicular cut. Cut end of rails 1/16" shorter than mark on each side to allow for fit into brackets.
10
10. A ttach post caps to posts (use of rubber
mallet may be required for secure attachment).
RUST-OLEUM® is a trademark of Rust-Oleum Corporation.
305 NOTE: Construction methods are always improving. Please refer to www.trex.com for the most up-to-date installation requirements.
Made with FlippingBook - Online Brochure Maker