HOW TO INSTALL HORIZONTAL RAILING CROSSOVER POST TO CROSSOVER POST/ CONTINUED TREX SIGNATURE ® Cutting Top Rail Insert and Cover
Attaching Bottom Rail Cover and Bottom Rail to Brackets
6
9
Top rail
3/4" (1.9 cm)
3/4" (1.9 cm)
6. S lide rail insert out and cut 3/4" (1.9 cm) FROM EACH SIDE of insert, then slide back inside rail and center. 7. M ark and cut top rail 7 Top rail
9. A lign flat cover on one side of bottom rail in slot on side of rail. Then starting from one end of rail snap cover onto opposing slot working down the length of rail. In some cases, GENTLE tapping with a rubber mallet may facilitate fastening.
cover same length as top rail for all top rail configurations.
10. Attaching Foot Block (when required) See instructions on page 85.
Installing Lower Rail to Brackets 11. P lace adhesive strips (provided) into bottom rail brackets, and then place bottom rail into brackets.
NOTE: Make sure surface is clean and dry.
11
Center balluster slot
Attaching Center Baluster to Bottom Rail
8
Inverted Bottom view
1
8. A ttach shorter, center baluster in center slot in bottom rail using two #8 x 1-1/4" (3.2 cm) screws (provided).
92
Made with FlippingBook - Online Brochure Maker