HOW TO INSTALL HORIZONTAL RAILING CROSSOVER POST TO CROSSOVER POST/ CONTINUED TREX SIGNATURE ® Installing Remaining Balusters into Bottom Rail
15
2
12
1
3
15. Attach “crowned" upper rail cover to upper rail by aligning cover on one side of rail. Then starting from one end of rail, snap cover onto opposing slot working down length of rail. GENTLE tapping with a rubber mallet may facilitate fastening.
12. Place remaining balusters into holes in lower rail by snapping fully into place. In some cases, GENTLE tapping with a rubber mallet may facilitate fastening.
Attachment of Bracket Covers, Skirts, and Caps
Attach Upper Railings
16
17
Trex Signature post
13
1
2
1
16. Attach corresponding bracket covers over opening in bottom rails. 17. Attach provided post skirt to bottom of posts when using Trex Signature posts.
18
13. Working from one end of upper rail, snap balusters into upper rail working down length of rail. Fasten center baluster into center slot using two #8 x 1-1/4" (3.2 cm) screws (provided).
18. Attach crossover post cap to crossover post.
14
14. At crossover post
locations using a 7/64" (0.28 cm) drill bit, pre- drill at marked location for attachment of
2
railing to crossover post bracket. Attach fasten upper rail to crossover post by installing screws diagonally through upper rail into post using two self-tapping screws each side (provided) . 1 7/64" (.28 cm)
NOTE: Pre-drilling is required.
94
Made with FlippingBook - Online Brochure Maker