Process Meters and Clamp Meters
Provide the versatility of a digital multimeter and loop calibrator and save time with no need to break the loop.
787B ProcessMeter ™ Double troubleshooting capabilities by combining the power of a digital multimeter and mA loop calibrator into one tool. • 20 mA DC current source/ measure/simulate • Simultaneous mA and % of scale readout • Fluke Connect ® compatibility for wireless data logging (with IR3000FC module) • Precision 1000 V, 440 mA true-rms digital multimeter • Frequency measurement to 20 kHz www.fluke.com/au/787B
715 Volt/mA Calibrator Outstanding performance, durability and reliability.
789 ProcessMeter ™ The 789 includes all the popular features of the 787 and adds: • 24 V loop power supply • 1200 ohm drive capability on mA source • HART mode setting with loop power and a built-in 250 ohm resistor • 0% and 100% buttons to toggle between 4 and 20 mA sourcing for a quick span check
• Measure loop current (0-20 mA, 4-20 mA) signals with very high accuracy of 0.015% and 1 mA resolution • Measure voltage output process signals from PLCs, transmitters • Source or simulate 24 mA loop current • Source voltage to 100 mV or 10 V • 24 V loop supply with simultaneous current measurement • Enhanced voltage and current measure and source accuracy • NIST traceable calibration www.fluke.com/au/715
• CAT IV 600 V rating www.fluke.com/au/789
772 Milliamp Process Clamp Meter
771 Milliamp Process Clamp Meter Saves time by making fast,
773 Milliamp Process Clamp Meter
Expanded features of the popular 771 mA clamp meter by adding loop power and mA sourcing to the capabilities. • Measure 4 to 20 mA signals with in-circuit measurement • Simultaneous mA in-circuit measurement with 24 V loop power for powering and testing transmitters • Source 4 to 20 mA signals for testing control system I/O or I/Ps • Automatically ramp or step the 4 to 20 mA output for remote testing www.fluke.com/au/772
The premier mA clamp meter, adds advanced troubleshooting features and voltage source/ measure for testing voltage I/O. Includes all the features of the 772 plus: • DC voltage sourcing and measurement, verify 24 V power supplies or test voltage I/O signals • Scaled mA output provides a continuous mA signal that corresponds to the 4 to 20 mA signal measured by the mA clamp • Simultaneously source and measure mA signals www.fluke.com/au/773
accurate measurements on 4-20 mA signal loops without breaking the circuit. • 0.01 mA resolution and sensitivity • Measure mA signals for PLC and control system analog I/O • Measure 10 to 50 mA signals in older control systems using the 99.9 mA range www.fluke.com/au/771
10
Electrical, Multifunction and mA Loop Calibration
Made with FlippingBook Learn more on our blog