UNPACKING AND ASSEMBLY : INDUCED DRAFT FACE MOUNTED BLOWER ASSEMBLY
INDUCED DRAFT FACE MOUNTED BLOWER ASSEMBLY Unpack the following blower assembly components:
Blower wheel and shaft key
•
Allen wrench
•
Motor (with power cord attached)
•
Motor mount plate
•
Motor mount spacer ring
•
• Motor mounting screws (4 x countersunk, socket head cap screws (SHCS)) • Motor mount gasket (approximately 12” in diameter x ½” thick) • Upper clean out cover and gasket (approximately 9” in diameter) • Bent flow stabilizer
THE MOTOR AND BLOWER ASSEMBLY IS HEAVY, APPROXIMATELY 45 LBS. DO NOT DROP AS YOU MAY SEVERELY DAMAGE IT. Each blower wheel is statically and
dynamically balanced at the factory.
1. Place the motor mount spacer ring over the shaft end of the motor and align the bolt holes with the threaded sockets on the motor body. Remove the rubber washer on the shaft of the motor. 2. Place the motor mount plate over the shaft end of the motor and align the counter sunk holes with the motor spacer ring and the threaded sockets on the motor body.
3. Insert the 4 countersunk, socket head cap screws and tighten.
4. Slide the motor mount gasket over the shaft and align the flat on the perimeter to the motor mount plate. If the holes of the gasket do not line up, flip the gasket over. The gasket only fits one way.
14
GARN® WHS 1000 and WHS 2000 Manual | © HY-C® Company LLC | October 2024
Made with FlippingBook - professional solution for displaying marketing and sales documents online