Pre Fabrication Guide
Steel Wire Cable Tray Systems
Introduction
Available in Electro-Zinc, Pre-Galvanised, Powder-Coated, Hot-Dip Galvanised, Steel Wire Cable Tray is offered in three depths - 30mm, 55mm and 106mm. A wide range of fittings is available to join and support the Steel Wire Cable Tray. The following section is intended to be used as a guide to fabricating Steel Wire Cable Tray fittings on site. A wide range of fittings and accessories are available to join the tray.
Reducers
Example of MC55300 - MC55200 MCCA x 3 or MCCB x 2 plus MCSP x 50mm
MC55300 and MC55100
Wire Cutting Directions
Typical Fabricated Reducer Components
CODE
COMPONENT
QTY
MCCA
x2
MCCA
x2
Incorrect
Correct
MCSP
x1
All bends are easily fabricated on-site!
Find us in the Beama best practice guide for additional installation instructions
Allied Tube & Conduit
302
Made with FlippingBook Digital Publishing Software