TREX SIGNATURE® X-SERIES™ HORIZONTAL FRAMELESS GLASS RAIL Installation Instructions
Outside
7
9
9. Orient flexible gasket as shown so that the flat side of the gasket is facing the glass. Starting at the bottom of the post, press the flexible gasket in between the glass and rigid gasket as shown until fully seated. If gasket extends above the
top edge of the glass once installed, trim off excess. TIP: Use warm soapy water if gasket is difficult to install. Clean off after use.
Final Installation Steps
7. Slide corner covers back onto X-Series Anchor Posts, and then slide/snap side covers back onto posts.
10
8
8. Adjust glass so it is
centered between posts as shown. Glass should be touching J-hook on both rigid gaskets.
2
4
3
10. Install top inserts, post caps, and bolt caps to complete installation. For bolt caps, align hex shadow line on inner cap with bolt head before installing outer cap.
4 Have Questions?
NOTE: Construction methods are always improving. Please ensure you have the most up-to-date installation instructions by visiting: trex.com
1–800–BUY–TREX
XGLASS-0725
Made with FlippingBook - Share PDF online