HY-GUARD EXCLUSION Product Guide

ANIMAL EXCLUSION || Architectural Steel Mesh Profiles

L-MESH

LOW PROFILE Z-MESH

HIGH PROFILE Z-MESH

RAML350

RALP1448B, RALP1491B

RA1448B, RA1491B RA3848B

PEST ARMOR™ RAML350 L-Mesh

RALP1448B Low Profile Z-Mesh

RALP1491B Low Profile Z-Mesh

RA1448B High Profile Z-Mesh

RA1491B High Profile Z-Mesh

RA3848B High Profile Z-Mesh

MESH [in]

1

1

1

1

1

3/8

LENGTH [in]

48

48

91-1/2

48

91-1/2

48

CASE PACK

20 PCS / 80 LF 40 PCS / 160 LF 21 PCS / 160 LF 40 PCS / 160 LF 21 PCS / 160 LF 40 PCS / 160 LF

AVAILABLE FINISHES:

INSTALLING PEST ARMOR™ ON OFFSET SURFACES

› Lay out sections of Pest Armor along the offset surface. › Install each section of Pest Armor by applying downward pressure to the bottom tab, while pushing up towards the second surface. Secure the bottom tab every 12”, using neoprene-washered screws (included), keeping the Pest Armor tight to both surfaces. › Overlap all seams 1”. Paint all edges cut during installation to seal Pest Armor™, protecting it from rust and corrosion.

TURNING PEST ARMOR™ 90° ON OFFSET SURFACES

› At the point of your desired 90° turn, make 1 relief cut on the top tab of your Pest Armor. Bend the Pest Armor 90° to meet the offset surface. › Flatten and secure the top tab as needed. Secure the bottom tab every 12” using neoprene-washered screws (included). › If necessary, add relief cuts to the bottom and middle tab to allow Pest Armor to flex for compounding angles (such as a roof ridge vent end cap). Start in the middle of the end cap for the first relief cut and then add one relief cut on each side, approximately 1” from the center cut. Add more cuts as necessary. Paint all edges cut during installation to seal Pest Armor™.

3

MADE IN ST. LOUIS, MISSOURI // USA

Made with FlippingBook - professional solution for displaying marketing and sales documents online