9.4 When installing the compressed air supply to the air manifold(s), refer to the diagrams below.
10.0 ELECTRICAL/ CONTROLS
NOTE: All of the electrical installation must be performed by a qualified electrician and in accordance with local, state, and national codes/regulations/laws (if any).
10.1 The blower motor is typically configured to operate with 208-230/460 volt, 60 cycle, and 3 phase electrical power unless specified otherwise with the equipment order. Electrical power is connected to the J-box on the blower section of the collector. Below the J-Box is a decal that confirms the voltage the motor was set up for at the
Page 10
sales@clean-air.com
1-866-665-1829
www.clean-air.com
Made with FlippingBook Online newsletter maker