18.5 Gently remove the bottom filter, exercising effort in keeping dust from falling inside the clean air duct opening 18.6 Place the filter cap over the clean air duct opening at the bottom (Picture 3). This will help prevent material from entering the clean air duct during the remainder of the filter replacements. Take note that the gaskets on the filters are located on the bottom of each filter.
Picture 3
18.7 Repeat steps 2 through 6, for remaining filters.
18.8 To install new filters remove the filter cap from the clean air duct opening and place new filter(s), taking care to install the filter(s) with the gasket down. Place filter cap with gasket side down on top of the top filter cartridge and centered on opening. Turn “T” handle, clockwise, down against filter cap so that the dimple on the filter cap penetrates the threaded bore of the “T” handle. Continue to rotate “T” handle until gaskets are approximately 30% compressed. (If over tightening you will see the outer edge of the filter pleats begin to curve.) Ensure that the filters and filter cap are aligned properly to facilitate a leak-free fit.
18.9 After all of the new filters have been installed, close and secure the Dust Collector Filter Access Door.
NOTE: Discard filters in accordance with all local, state, and national codes/regulations.
Page 18
sales@clean-air.com
1-866-665-1829
www.clean-air.com
Made with FlippingBook Online newsletter maker