The EC-Series DC Torque Control System Calibration Procedure explains how to verify, calibrate, and adjust torque output for optimal fastening performance. Learn the four key calibration scenarios, including factory calibration, preset torque certification, on-site verification, and torque transfer to the application, to ensure accurate, repeatable results and process confidence. Designed for a cleanroom environment, the FG-CR cleanroom screwdriver is manufactured using a high-grade, low-outgassing powder coat. The tools feature dynamic wear-resistant internal seals to prevent grease leakage and minimize airborne contamination.
NOW AVAILABLE!
MOUNTZ TORQUE ONSITE CALIBRATION SERVICES We’re excited to announce a new service from Mountz that makes your life a little easier – ISO17025 onsite calibration for hand tools and electric drivers, now available at your location.
DETAILS Service Area If you're within 1 hour of driving from our Foley, AL or San Jose, CA locations, we’ll bring our expert calibration right to your doorstep! Service Fees: Setup Fee (Part Number 990098): Charged on every onsite order to cover the setup of the calibration area. Travel Time (Part Number 990099): Charged each way (to and from) for every day of onsite service. Calibration Options: When scheduling your service, please specify the calibration method you prefer based on the tool type and range. Note: Sensors and analyzers cannot be calibrated onsite at this time.
Tool Types and Estimated Process Times: Pre-set screwdrivers and wrenches (up to 250 lbf-ft): 8 minutes per tool (7.5 tools per hour, 35-40 tools per day) Adjustable screwdrivers and wrenches (up to 250 lbf-ft): 17.5 minutes per tool (3.5 tools per hour, 18 tools per day) Electric tools (1-point calibration): 20 minutes per tool (3 tools per hour, 16 tools per day) Electric tools (3-point calibration): 30 minutes per tool (2 tools per hour, 11 tools per day)
Submit a Service Request
go.mountztorque.com/usa-service
Page 1Made with FlippingBook Annual report maker