Screw Count Settings
Screw count parameters are set for presets and models.
Cycle Starts Signal select : Count start (IN) / end (OUT)
1) No signal, auto start (Auto) - auto reset to total number after “0”
2) Sensor or switch with one trigger pulse - Count starts with only trigger pulse. Counting is valid until complete or reset. Reset calls count NG
3) One trigger pulse with timer for counting - Counting should be completed within the time of timer from the trigger pulse, otherwise count NG 4) One trigger pulse to start counting, another trigger pulse to stop counting and evaluate OK or NG. Any remaining number calls count NG
Time Limit : Only set if sensor signal is ‘start pulse+ time limit’ The fastening time limit from Count START for NG judgment. The fastening work should be finished within the set time. Otherwise, the work piece leave the working area
Total Count: This parameter is only used with Presets (not used for Model) – set value 0 to 99.
Counting is set in Model with different values for each fastening step.
SILICON VALLEY HEADQUARTERS 1080 North 11th Street, San Jose, CA 95112 | Phone: (408) 292-2214 | Fax: (408) 292-2733 | mountztorque.com
27
Made with FlippingBook Annual report maker