Controller System Start-up Process
Before attempting to make any settings, it is essential to initialize the controller and electric screwdriver as a set, as the information stored within the controller during testing at the time of manufacture may not correlate with the screwdriver shipped with the system. This process should be used when turning on the unit or changing an electric screwdriver. Connect the screwdriver to the controller with the supplied cable Connect the controller power cable Power on the controller with a power switch The controller screen will display an error message as below, and the screwdriver is locked. [E114]
Screwdriver recognition error
Note: Power off controller before disconnecting electric screwdriver
Press Parameter
Press Controller
SILICON VALLEY HEADQUARTERS 1080 North 11th Street, San Jose, CA 95112 | Phone: (408) 292-2214 | Fax: (408) 292-2733 | mountztorque.com
3
Made with FlippingBook Annual report maker