Torque Calibration and Compensation
Torque calibration : It is the master calibration for whole torque range of the tool, saved in the tool memory. The F/R switch should be at Reverse position before writing the new value.
The torque calibration could be utilized to change the electric screwdriver calibration. The screwdriver should be recalibrated if replacing the motor or gear mechanism.
Torque calibration on the controller panel
Torque calibration (%). The default value is 100%
Total adjustable range is +/- 10% ( 90% to 110% )
Example to increase the output torque 5%, key in 105(%). The changes to the torque calibration percent will effect the entire range of the tool. The torque calibration percent is stored in the memory chip in the tool. So it can be still effective on other controller.
The results can vary based on test conditions:
- Type of the rundown simulation ( Hard joint, semi-elastic or Soft joint ) - Rundown screw diameter - Pressing pressure of the tool - Washer, lubricant and run down screw material
SILICON VALLEY HEADQUARTERS 1080 North 11th Street, San Jose, CA 95112 | Phone: (408) 292-2214 | Fax: (408) 292-2733 | mountztorque.com
58
Made with FlippingBook Annual report maker