Casework Installation

Where stretchers are used between legs, screw male half of Mod-ez clip to the leg using the screws provided and the pre-drill holes. Place stretcher in position and snap the two halves of the Mod-ez clips together. (Female half of Mod-ez clip is installed on stretcher at factory.) Repeat process with spreaders when spreaders are provided. When legs have been installed, place vinyl leg shoes over the bottom of the leg, if provided, and turn apron right side up. Level with the leveling bolt or shims and fasten to floor with leg hold-downs if provided. INSTALLATION OF FILLER PANELS AND SCRIBE STRIPS FOR WOOD When all plumbing and/or wiring have been completed, install the filler panels and scribe strips. In general, filler panels and scribe strips are used to fill in any openings left between cabinet units and the wall, or open spaces between cabinets. Careful installation of these items will improve the appearance of the furniture, and aid in keeping the laboratory clean. WALL & CENTER TABLE FLUSH FILLER PANELS Plumbing space wall and center table filler panels are normally 7” to 8” wide, and are furnished with two 3/4” x 3/4” mounting cleats. They are installed flush as illustrated in Figure 15. For a wall table filler, attach one cleat to the wall, and the other cleat to the rear of the base unit with #9 1-1/4” flat head wood screw. (Use a No. 5/32” drill). The filler panel is attached to the cleats with #6 round head wood screws. For center table filler attach the two cleats to the rear of the base units with a #9 - 1 1/4” flat head wood screws. The filler panel is attached to the cleats with #6 - 3/4” round head wood screws. Be sure to attach the rear cleat to the wall before cases are set.

DiversifiedCasework.com | info@DiversifiedCasework.com | 877.348.9663

Made with FlippingBook interactive PDF creator