Tremco TPA Single Ply Roofing Systems Prefabricated Vent Pipe Boots
Guarantee/Warranty: Tremco, Inc. warrants Tremco TPA Single Ply Roofing Systems Prefabricated Vent Pipe Boots to be free of defects and to meet published physical properties when tested according to ASTM and Tremco standards. Under this warranty, any product that is proved to be defective when applied in accordance with our written instructions, and in applications recom- mended by Tremco as suitable for this product will be replaced with like product at no charge. THIS IS BUYERS SOLE AND EXCLUSIVE REMEDY. All claims concerning product defects must be made in writing within twelve (12) months of shipment. The absence of such claims in writing during this period will constitute a waiver of all claims with respect to such product. This warranty shall be IN LIEU OF any other warranty, express or implied, including but not limited to, any implied warranty of MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE. Technical Services: Your local Tremco Representative, working with the Technical Service Staff, can help analyze conditions and needs to develop recommendations for special applications. The services of the Tremco Research Center, which has earned a unique reputation in weather- proofing technology, complement and extend the services of the Tremco Technical Service staff. Statement of Policy and Responsibility: Tremco takes responsibility for furnishing quality materials and for providing specifications and recommenda- tions for their proper installation. As neither Tremco itself not its Representatives practice architecture or engineering, Tremco offers no opinion on, and expressly disclaims any responsibility for the soundness of any structure on which its products may be applied. If questions arise as to the soundness of a structure or its ability to support a planned installation properly, the Owner should obtain the opinion of competent structural engineers before proceeding. Tremco accepts no liability for any structural failure or for resultant damages, and no Tremco Representative is authorized to vary this disclaimer.
Basic Use: The one-piece vent pipe boots are designed to fit circular roof penetrations 1" to 8" in diameter that provide top access. They are designed to add ease to the installation process while offering increased watertight security and improved aesthetics. Product Specifications: Material: TPA unreinforced membrane Size: Small - for 1" to 4" stacks Large - for 4" to 8" stacks Packaging: The vent pipe boots are packaged 10 per carton. Installation Procedures: 1. Existing Pipe Flashing must be removed. 2. Install plates and fasteners that secure field sheet as close to the penetration as possible. 3. Each boot is stepped in increments that will fit standard pipes. The top of the boot should be cut around the “step” which allows a stretch fit between the top of the boot over the stack. 4. Place the boot over the vent pipe. 5. Pull the flange down to the roof, stretching the collar portion around the vent pipe. 6. Inside the top of the boot shall be caulked to prevent water entry and a stainless steel hose clamp must be installed to secure the top edge of the boot to the vent pipe. 7. The flange of the boot is pre-scored and shall be cut at the circular score and then heat-welded (minimum 2") onto the TPA field membrane. 8. Do not split the boot. If the boot cannot be installed intact, use field fabricated flashing per Tremco details. 9. Tremco vent pipe boots can only be installed by hot-air heat-welding. Availability and Cost: Contact your local Tremco Roofing Representative for pricing and availability. For the name and number of your Representative, call the Roofing Division at 216/292-5000. Maintenance: Your local Tremco Roofing Representative can provide you with effective maintenance procedures which may vary, depending upon specific conditions. Periodic inspections, early repairs and preventative maintenance are all part of a sound roof program.
Roofing & Weatherproofing Peace of Mind™
Made with FlippingBook - Online magazine maker