HOW TO INSTALL ROD RAIL STANDARD STAIR RAILING/ CONTINUED TREX SIGNATURE ®
Attachment of Foot Block (where recommended)
31
28
4
2
31.Drop assembled stair rod rail panel into brackets.
28.Temporarily drop assembled stair rod rail panel into brackets. To ensure proper location place foot block towards the nose of the stair tread along the side of the bottom rail. Mark location of angle on foot block and cut on mark. Then place foot block under the center of the bottom rail. Mark placement location of the base.
Attaching Stair Panel to Brackets
32
33
29
32.A ttach bottom stair rail to bottom stair bracket using two self-tapping screws (provided) on each side of bracket. 33.Attach top stair rail to top stair bracket (all types) using two self-tapping screws (provided) on each side of stair bracket.
29.Place base (smaller side facing down) on decking surface. Pre-drill using a 3/16” bit. Attach base of foot block using one screw at an angle through base and into decking.
34
30.After attached, use a
30
rubber mallet along with scrap piece of wood to tap foot block until it locks into place.
34.Using a mallet, install top rail cover.
7
Have Questions? 1–800–BUY–TREX
NOTE: Construction methods are always improving. Please ensure you have the most up-to-date installation instructions by visiting: trex.com
TRRSR-0422
Made with FlippingBook - PDF hosting