TREX® ROD RAIL STAIR RAILING Installation Instructions
HOW TO INSTALL ROD RAIL STAIR CROSSOVER SWIVEL BRACKETS/ CONTINUED TREX SIGNATURE ® 14. Attachment of Foot Block (where recommended) See instructions on page 7. Attachment of Stair 16. For stair crossover post configuration, fasten upper stair rail to swivel crossover post bracket 16
15
Panel to Stair Brackets 15. A ttach bottom stair rail to bottom stair bracket using two self-tapping screws (provided) on each side of bracket.
by installing screws diagonally through crossover stair bracket into upper rail using
two self-tapping screws (provided) on each side. 17. Attachment of Bracket Covers, Skirts, and Caps See instructions on page 8.
HOW TO INSTALL COCKTAIL ROD RAIL STAIR RAILING TREX SIGNATURE ®
1. Installing Pressure-treated Posts, Post Sleeves,and Skirts to Use with Trex Signature Railing
See instructions on page 2.
2. Installing Brackets Follow previous stair instructions for the installation of desired brackets, making sure that all dimensions are calculated before installation, and ensuring deck board is placed in correct location.
Cutting Top Stair Rail NOTE: THE TOP RAIL AND TOP RAIL COVER WILL NEED TO BE CUT AT APPROPRIATE ANGLE ON THE END OF THE RAIL THAT CONNECTS TO THE UPPER FIXED BRACKET, SO THAT WHEN THE RAIL IS INSTALLED IT SITS FLUSH WITH THE END OF THE BRACKET AS SHOWN.
IMPORTANT NOTES: » O nly for use with pressure-treated 4 x 4 post (3.5” nominal square) and 4” x 4” (102 mm x 102 mm) post sleeve. Trex Signature posts, Trex post mounts or joist mount posts cannot be used with Trex Signature Cocktail Rod Rail stair railing. Cutting post and post sleeve only applies to the Cocktail style railing. » D O NOT CUT LOWER POST/POST SLEEVES UNTIL ROD RAIL STAIR PANEL IS FULLY INSTALLED. » When referring to previous instructions referenced, disregard all crossover post instructions as these cannot be used with Cocktail railing. » T HE DECK BOARD USED IN COCKTAIL ROD RAIL STAIR WILL NEED TO TERMINATE AT THE UPPER STAIR POST AS SHOWN ABOVE. THE DECK BOARD WILL HAVE TO BE TOENAILED INTO THE SIDE OF THE POST IN THESE AREAS USING 2 APPROPRIATE COMPOSITE DECKING SCREWS – PRE-DRILLING IS RECOMMENDED. » Do Not use Enhance for top board.
Post
Top stair rail
Upper bracket
10
Have Questions? 1–800–BUY–TREX
NOTE: Construction methods are always improving. Please ensure you have the most up-to-date installation instructions by visiting: trex.com
TRRSR-0422
Made with FlippingBook - PDF hosting