HOW TO INSTALL ROD RAIL STANDARD RAILING/ CONTINUED TREX SIGNATURE
22
27
22. A fter attached, use a rubber mallet along with scrap piece of
Rod stiener
wood to tap foot block until it locks into place.
23
Installing Lower Rail to Brackets 23. P lace adhesive strips (provided) into bottom rail brackets. NOTE: Make sure surface is clean and dry.
27. Place rod stiffener inside rail channel.
Installing Top Rail Cover
28
24
28. Using a mallet, install top rail cover.
Attachment of Bracket Covers, Skirts, and Caps
29
30
Signature post
24. Drop assembled rod rail panel into brackets.
Attaching Panel to Brackets 25. Attach top rail to top bracket using two #10 x 1" self-tapping screws (provided) on each side of bracket.
25
29.Attach corresponding bracket covers over opening in top and bottom rails. 30.Attach provided post skirt to bottom of posts when using Trex Signature posts.
Inserting Rod Rail Stiffener – For Rail Sections Over 6'
32
31
26
Rod stiener
Post sleeve
Signature post
31. A ttach post caps to Trex Signature posts. (Use of rubber mallet may be required for secure attachment.)
26. Attach tape (qty 6 provided) to alternating sides of the rod stiffener as shown.
32.Secure post caps with silicone or PVC adhesive. (apply adhesive on the inside self-centering/corner tabs).
7
Have Questions? 1–800–BUY–TREX
NOTE: Construction methods are always improving. Please ensure you have the most up-to-date installation instructions by visiting: trex.com
TRRHR-0825
Made with FlippingBook - PDF hosting