TREX ® SIGNATURE ® HORIZONTAL RAILING Installation Instructions
HOW TO INSTALL HORIZONTAL RAILING POST TO CROSSOVER POST/ CONTINUED TREX SIGNATURE
16
Installing Lower Rail to Brackets
14. A ttach top rail
to top bracket using two #10 x 1" self-tapping screws (provided) on each side of bracket.
11
11. P lace adhesive strips (provided) into bottom rail brackets, and then place bottom rail into brackets (proceed to step 12). NOTE: Make sure surface is clean and dry.
1
15. A t crossover post
15
location, using a 7/64" (0.28 cm) drill bit, pre- drill at marked location for attachment of
Installing Remaining Balusters into Bottom Rail
2
12
railing to crossover post bracket. Attach fasten upper rail to crossover post bracket by installing screws diagonally through upper rail into post using two self-tapping screws each side (provided) . NOTE: Pre-drilling is required. Its best practice to pre-drill a single hole, then attach screw, and continue in this order. 1 7/64" (.28 cm)
12. Place remaining balusters into holes in lower rail by snapping fully into place. In some cases, GENTLE tapping with a rubber mallet may facilitate fastening. Attach Upper Railings
16
13
16. A ttach “crowned” upper rail cover to upper rail by aligning cover on one side of rail. Then starting from one end of rail, snap cover onto opposing slot working down length of rail. In some cases, GENTLE tapping with a rubber mallet may facilitate fastening.
13. W orking from one end of upper rail, snap balusters into upper rail working down length of rail. Fasten center baluster into center slot using two #8 x 1-1/4" (3.2 cm) screws (provided).
10
Have Questions? 1–800–BUY–TREX
NOTE: Construction methods are always improving. Please ensure you have the most up-to-date installation instructions by visiting: trex.com
TR-HZSIGNATURE-0825
Made with FlippingBook Online newsletter maker