HOW TO INSTALL HORIZONTAL RAILING CROSSOVER POST TO CROSSOVER POST/ POST/ CONTINUED – TREX SIGNATURE STANDARD
Cutting Top Rail Insert and Cover
Attaching Bottom Rail Cover
6
9
Top rail
3/4" (1.9 cm)
3/4" (1.9 cm)
9. A lign flat cover on one side of bottom rail in slot on side of rail. Then starting from one end of rail snap cover onto opposing slot working down the length of rail. In some cases, GENTLE tapping with a rubber mallet may facilitate fastening. 10. Attaching Foot Block (when required) See instructions on page 6. Installing Lower Rail to Brackets 11. P lace adhesive strips 11
6. S lide rail insert out and cut 3/4" (1.9 cm) FROM EACH SIDE of insert, then slide back inside rail and center.
7
7. M ark and cut top rail cover same length as top rail for all top rail configurations.
Top rail
(provided) into bottom rail brackets, and then place bottom rail into brackets (proceed to step 12).
Top rail cover
1
Attaching Center Baluster to Bottom Rail
Center balluster slot
8
NOTE: Make sure surface is clean and dry. Installing Remaining Balusters into Bottom Rail
12
Inverted Bottom view
8. A ttach shorter, center baluster in center slot in bottom rail using two #8 x 1-1/4" (3.2 cm) screws (provided).
12. Place remaining balusters into holes in lower rail by snapping fully into place. In some cases, GENTLE tapping with a rubber mallet may facilitate fastening.
13
Have Questions? 1–800–BUY–TREX
NOTE: Construction methods are always improving. Please ensure you have the most up-to-date installation instructions by visiting: trex.com
TR-HZSIGNATURE-0825
Made with FlippingBook Online newsletter maker