SmartJack V4.0 Installation Telco Photoeye Wiring SmartJack Operators include a pre-wired 11-pin amplifier base for Telco photoeyes installed right in the control box (figures 13-14). Just wire in the transmitter and receiver eyes to the base and plug in the amplifier. Photoelectrics and other signalling devices must use DC amperage. Telco Wiring Instructions Transmitter (LT)- Eyes- Connect Black to #7 on the Base and Red to #5 on the Base. Receiver (LR)- Eyes- Connect the Yellow to #6 and the non-shielded to #8 on the base. Amplifier- Plug-in to the 11-pin base. Figure 13 11-pin Base
Radio Control Wiring Radio Control Receivers are easily wired to SmartJack Operators. 850LM & MVP-RE Shown
Figure 14
MVP-RE
850LM
Receiver (Color)
Control Box
Red (24V) White (24N)
24H 24N 220 240 261 260
Orange 1 (Open) Black 1 (Close) Grey 1 (Stop) Grey 2 (Jumper) Jumpers Required Orange 2 to Black 2 Black 2 to Grey 2
Other Photoelectrics & Accessories Numerous other safety and entry devices and accessories such as: other photoelectric systems, loop detectors, motion detectors, entry systems and many others can be integrated with the SmartJack. Refer to the wiring diagram or contact your company representative for specific details.
10
800-233-1487
Fax: (218) 751-6551
Carwashdoors.com
Made with FlippingBook - Online catalogs