SmartJack V4.0 Installation
Test the motor direction by using the open/close push buttons on the face of the control box (when powered up) to run the operator. If the operator drive shaft rotates in the opposite direction of the command given (open/close), swap the T1 or T2 wires coming from the motor. When complete reattached the roller chain and ensure the door is in the closed (down) position and unlocked before continuing Start-Up: Step 1 Turn the "Hand/Auto mode" switch on the front of the control box to the "Auto" Mode setting Step 2 Open the Control Box cover and locate the PLC Display inside the box Step 3 Turn the main power on via the primary power switch or breaker, you will see the Control Box power up and the display turn on. Step 4 On the controller (top left Corner in the box, Press " 1 " for settings. You'll see the "Quick Set-up Mode" . Follow the simple instructions on the display to set the doors open and close limits. Quick Set-up Mode At the displays’ command, run the operator in the up direction until you have reached the final “Open” position. You will have to press the open button on the face of the Control Box to do this. When done, press the “enter” key. The screen should read “Set-up Completed”. At that point, Press “enter” and then press “ 2 ” to exit.. Test Operation Before testing and finalizing the installation see the SmartJack Door Controller Programming & Setup Manual for important programming, safetyand setup information. Important To test the direction, you must first remove the roller chain. Pre-Start-Up: Once the SmartJack has been properly installed and wired, the motor direction should be tested to make sure the motor is wired properly.
PLC Display
11
800-233-1487
Fax: (218) 751-6551
Carwashdoors.com
Made with FlippingBook - Online catalogs