SmartJack V4.0 Installation Introduction
The SmartJack V4.0 VFD Electric Garage Door Operator is easily installed and wired and consists of a high voltage motor/gearbox assembly with a low voltage proximity sensor acting as an encoder. The system is coupled with a high-quality control box that handles all of the programming and functionality of the product and the operator includes a 24V. 30mm proximity "home sensor" that is mounted to the wall for "close limit" calibration. Wiring consists of high voltage wiring from the motor & brake (motor/ gearbox) to the main control box and separate low voltage wiring for the proximity sensor, home sensor and accessories Numerous control devices can be wired in as inputs for open/close & stop functionality of the product. Four outputs are available for signalling when the door is fully open, closed, in motion,or when the door is closing. These outputs can be used to control other devices such as: warning horns or lights, monitors or door interlocks or other mechanisms including vehicle wash or HVAC equipment.
WARNING! Automated doors can be dangerous if used unsafely or improperly installed. If operated in these conditions, automated doors may cause bodily harm or death.
Motor/Gearbox Mounting Area The SmartJack Operator motor/gearbox must be mounted to a solid, well-prepared surface that is adequate to handle the weight of the operator and accommodate stresses of continual operation of the door size and weight without movement.
3
800-233-1487
Fax: (218) 751-6551
Carwashdoors.com
Made with FlippingBook - Online catalogs