SmartJack V4.0 Installation
Getting Started Determine where you will be mounting the operator.
Typically, the SmartJack Operator has been ordered for the correct mounting side of the door prior to deliver. If the operator was not properly ordered and needs to be used for the other side of the door, it can be changed easily in the field. For instructions, please see our video on our You Tube channel at https://www.youtube. com/watch?v=2PVeWNUHGYA.
Left Hand Shown
Installing the Motor/Gearbox Unit
Door Sprocket
Step 1 Slide the door sprocket on the door shaft (Figure 1). Position the set screws so they are easily accessible for service. Leave enough room for mounting a bearing plate on the end of the shaft for support later.
Figure 1
Step 2 Close the door and lock it down for safety.
Step 3 Assemble the chain by adding the master link onto the supplied #50 chain. When done, place the chain on the door sprocket as pictured. (figure 2) Tip - When the installation is complete, the center of the operator drive shaft dimension to the center of the door shaft should equal 12"-16".
Chain
Figure 2
Before continuing...... The proximity sensor is mounted near the drive sprocket located on the side of the SmartJack gearbox. First, check to see if it has loosened with handling or shipping. Before moving forward make sure the end of the proximity sensor clears the round portion (high point) of the 3-lobed cam by approximately 1/16 of an inch or less. The proximity sensor and bracket bolts should be tightened securely so they will not move vibrate or move during operation.
Proximity Sensor
3-Lobed Cam
4
800-233-1487
Fax: (218) 751-6551
Carwashdoors.com
Made with FlippingBook - Online catalogs