HOW TO INSTALL STANDARD HORIZONTAL GLASS RAILING/ CONTINUED TREX SIGNATURE ®
Installing Bottom Rail
Centering the Glass and Installing into Bottom Rail
11
14
2
1
2 1/2" (6.4 cm)
11. P lace adhesive strips (provided) into bottom rail brackets, and then place bottom rail into brackets.
14. F or full span installation, make a temporary mark on the bottom rail (example: use removable tape) 2-1/2” from each post. This will allow for glass to be centered between posts on bottom rail. For all other spans, make sure glass is centered BEFORE installing into bottom rail. WARNING : DO NOT exceed 4" between glass and post. THIS IS IMPORTANT AS THE GLASS MUST BE CENTERED ON THE BOTTOM RAIL BEFORE INSTALLATION, AS THIS IS VERY DIFFICULT TO REMOVE IF PLACED INCORRECTLY.
NOTE: Make sure surface is clean and dry.
Cutting Gaskets
12
15
12. C ut both bottom sill gasket and top head gasket to the same length of glass panel.
Installing Bottom Sill Gasket
13
15. P ress glass panel (with bottom sill gasket on glass) firmly into the bottom rail.
NOTE: Make sure glass is being secured by hand until final assembly of the top rail.
13. Lay glass on clean soft surface and install the bottom sill gasket onto the bottom edge of the glass panel.
5
Have Questions? 1–800–BUY–TREX
NOTE: Construction methods are always improving. Please ensure you have the most up-to-date installation instructions by visiting: trex.com
THGR-0323
Made with FlippingBook - PDF hosting