FMS Users Guide

ENGLISH

4.5.5 INSTALLING TESTING FIXTURE Test fixtures feature a 15.9mm diameter attachment. This attachments slides onto the Base Clevis and Load Cell Clevis. The test fixture is secured to the Clevis adapter using a 8mm grip pin. Both Clevis devices include two (2) locking rings. Use the rings to tighten the clevis to the sensor, base and test fixture.

4.6 INSTALLING ANTI-SKID MOUNTING CLIPS Anti-skid mounting clips are supplied with the FMS1000 and FMS5000 Series test frames and may be used to permanently secure the frame to the desktop. These clips are recommended per IEC 61010 safety standards • Remove the four (4) rubber mounting feet on your FMS frame. • Place a mounting clip onto each of the threaded feet. • Screw the feet back into the FMS base. • Arrange the mounting clips so that each one extends outward away from the FMS base. • Use an appropriate screw to affix the mounting clip to the work surface where the FMS will be used. Make sure that there is no movementof the machine and that the machine is tightly held in contact with the work surface prior to operation. IMPORTANT You should check that the machine is secured tightly against the work surface prior to each use. Install Bench Clip between rubber foot and bottom cover plate.

Remove the mounting feet on your FMS frame and insert a mounting clip onto each foot. Re-thread the mounting feet into the base. Use all four mounting clips to properly affix the machine to the surface. Secure the FMS by screwing the mounting clips into the work surface. Make sure that the machine is tightly connected and that there is no amount of frame movement on the surface prior to use.

14 PKG08823 -UMFMS

Made with FlippingBook - professional solution for displaying marketing and sales documents online