ENGLISH
5.0 SYSTEM CONTROLS This section will describe the controls used with your FMS Series force measurement system to perform tests. 5.1 FMS TEST FRAME The majority of controls for your FMS Series force measurement system are located on your FMS Series frame. These are described in the following sections. 5.1.1 EMERGENCY STOP SWITCH The Emergency Stop Switch is located on the left-hand side of the FMS base. This switch interrupts power to the electrical drive system and brings the system to a stop as quickly as possible. IMPORTANT Engaging the Emergency Stop Switch does not remove power to the system. When the Emergency Stop Switch is engaged, power to the drive system is interrupted. No crosshead movement is possible. When operated, the Emergency Stop Switch locks down into a closed position. The crosshead movement is disabled. To reset or disengage the Emergency Stop Switch, press down and turn counter-clockwise. The switch will release upwards and return power to the drive system.
5.1.2 POWER SWITCH The main power switch for your FMS Series frame is located on the back of the machine. • Connect the machine to a source power outlet. • Turn the On/Off switch to the ON position to operate. • When your machine is not being used, turn the power switch to the OFF position. 5.1.3 JOG SWITCH The Jog Switch lets you move the crosshead UP and DOWN. When using the Jog Switch, pressing the switch cause the crosshead velocity to increase from zero to full velocity (60 inches per minute / 1525mm per minute) in about 3 seconds. You may restrict the maximum velocity using the L2 Controller Motion Settings. JOG UP - press the up portion of the switch to cause the crosshead to move upward. Release the switch to stop motion. JOG DOWN - press the down portion of the switch to cause the crosshead to move downward. Release the switch to stop motion.
Emergency Stop Switch
Jog Switch
Start/Stop Switch
PKG08823 -UMFMS 15
Made with FlippingBook - professional solution for displaying marketing and sales documents online