FMS Users Guide

ENGLISH

5.1.4 TEST START/STOP SWITCH Use the START/STOP Switch to start or stop a test. An LED on the START/ STOP Switch illuminates to show that a test is in progress or that the tester is ready to perform a test. IMPORTANT Starrett recommends that you use the START/STOP Switch to start or stop your test setups.

5.2.1 POWER SWITCH The power switch is located on the side of the L2 Controller. The L2 Controller should be connected to its own power source using a 3-wire grounded power cord. The power switch is pressed to turn power to the tablet computer ON or OFF.

5.1.5 TRAVEL LIMIT SWITCHES Limit Switches are located on the side of the column and used to restrict crosshead travel. Position your upper and lower travel limit switches so that they are approximately 2-3 inches above/below where your crosshead will stop during a normal test procedure. These travel limits will stop the crosshead should the crosshead come into contact with one of the limits. 5.2 L2 CONTROLLER This section will describe the main operational controls available on the L2 Controller with L2 software for force measurement.

16 PKG08823 -UMFMS

Made with FlippingBook - professional solution for displaying marketing and sales documents online