FMS Users Guide

ENGLISH

5.2.2 START/STOP TARGET The L2 Controller's main operating displays have a control section. The control section is located beneath the digital read out section where the measured load (L) or distance (D) are displayed. The control section will display START TEST when a test is ready to be performed. It will display STOP TEST when a test is being performed. You may control a test's START or STOP using the touch target in the control section, however, Starrett recommends that you use the START/STOP button since continued pressing on the L2 Controller display may cause permanent scratching due to finger nails. IMPORTANT The L2 Controller is a touch screen operated tablet personal computer. Always touch targets using the pad of a finger tip rather than the finger nails. Touching targets with the finger nail can scratch the display surface.

During an active RUN, the Limit setpoint is displayed. In this example the tension load limit of 38N is shown above the currently measured load of 14.130N.

The Overlay target is used during the Graph View. This allows you to select multiple RUNS for graphing together. The Runs List shows the current number of Runs performed. In this example, we are running Run 2. Run 1 is listed.

The Data View shows the results from the previous test RUN (Run 1).

The Status Block reports the current step being performed for the test setup. Shown is the test direction (tension/pull), the Load Limit (38.000N) and the Test Speed (20.000 in/min). The Step Number (2) is also displayed.

This symbol represents the Data View. It is highlighted to show that you are viewing the Data View format. The other symbol represents the Graph View. You may also perform a test Run while in the Graph View.

PKG08823 -UMFMS 17

Made with FlippingBook - professional solution for displaying marketing and sales documents online