USC
Stationary cylinder + chuck unit Ø 140 - 260 mm ■ Can be equipped with different types of chucks ■ With stroke control
Pneumatic static cylinder
Application/customer benefits • Gripping of components on vertical or horizontal machining centers Technical features • Standard pneumatic cylinder can be equipped with various type of chucks: - 2 / 3 / 4 jaws versions depending on chuck model and diameter - Standard or sealed, depending on applied chuck - Master jaw with serration or Tongue & Groove available - Normal or long stroke depending on chuck model and diameter • Continuous air pressure required • Optional SAB safety valve to hold pressure during pallet transfer Remark: The clamping unit consists of static cylinder + connection kit + chuck to be selected.
For chuck details, please see the technical data of the selected chuck.
Standard equipment Static cylinder the connection kit must be added, see the table on next page Accessories
Ordering example Please see the below table for part numbers and part descriptions
Valve SAB1 Id. No. 27581610 for USC 140/170 Valve SAB2 Id. No. 27581620 for USC 210/260 Mounting brackets
■ USC-AN = cylinder equipped with a 2 / 3 jaw chuck type AN-(normal stroke). Chuck until to Ø 315 mm ■ USC-AL = cylinder equipped with a 2 / 3 jaw chuck type AL-(long stroke). Chuck until to Ø 315 mm ■ USC-TS = cylinder equipped with a 2 / 3 jaw chuck type TS-. Chuck from Ø 135 to 315 mm ■ USC-TX = cylinder equipped with a 3 jaw chuck. Chuck from Ø 170 to 315 mm ■ USC-AP = cylinder equipped with a 3 jaw chuck type AP- (normal stroke). Chuck until to Ø 315 mm ■ USC-APL = cylinder equipped with a 3 jaw chuck type APL- (long stroke). Chuck Ø 170 to 315 mm a l e m a i s a l e m a i s a l e m a i s
s
a l e
m a i
AP- Ø 170-315 APL- Ø 215-315 TS-TX Ø 135-315
AN- AL- Ø 125-315 (2 / 3 / 4 jaws)
Connection kit
USC Cylinder
s
a l e
m a i
Stroke control The stroke control system consists of two built in magnets and two external sensors (Id.-Nr. 71834910) reading the axial position of the cylinder piston and consequently of chuck jaws mounted on it. The stroke control gives the following signals: „chuck fully open“, „chuck fully closed“ or „part clamped“ positions.
Technical data SMW-AUTOBLOK Type Id. No. Piston area-chuck (open) Piston area-chuck (closed) Max. operating pressure
USC 140 97501407
USC 170 97501702
USC 210 97502106
USC 260 97502601
133 126
189 176
269 249
434 409
cm² cm² bar mm
7
7
7
7
Piston stroke
17
22 11
26 16 15
31 26
Pushforce at 6 bar Pullforce at 6 bar Cylinder unit mass
kN kN kg
8
7.5 3.3
10.5
24.5 12.5
5
7
352 SMW-AUTOBLOK
Made with FlippingBook Publishing Software