HOW TO INSTALL STANDARD RAILING/ CONTINUED TREX TRANSCEND
Option
11
After top rail is
11. S lide baluster spacer up and snap into top rail. Place optional top rail gaskets on each end of rail. TIP: Use soapy water on balusters when sliding baluster spacer up to avoid potential scratching of balusters. Attaching Post Caps and Installing Foot Blocks 12. S ecure post caps with silicone or PVC adhesive (apply adhesive on the inside self-centering/ corner tabs). Attach
fully installed, place aluminum baluster
adaptor strip into channel of top rail, ensuring that it’s fully seated into the channel. When rail lengths are non-standard, the
adaptor strip will need to be cut 2 1/2" (64mm) shorter than the rail to allow clearance for the RBS's on each end.
12
9b
Placing Baluster Spacers 9b. S nap baluster spacer into bottom rail. Place inverted baluster spacer on top of first baluster spacer.
foot block per foot block instructions.
NOTE: Clean up any excess adhesive before it dries.
10
Attaching Balusters 10. Place baluster into
both baluster spacers, ensuring that balusters are fully seated into the channel. Working at a slight angle, maneuver balusters into top rail.
HOW TO INSTALL CONTINUOUS (OVER THE POST) COCKTAIL RAILING
IMPORTANT NOTES: » 6 x 6 post sleeve cannot be used. Trex Post Mounts or Joist Mount Posts cannot be used.
1. Installing Pressure-Treated Posts See instructions on page 3.
5
Have Questions? 1–800–BUY–TREX
NOTE: Construction methods are always improving. Please ensure you have the most up-to-date installation instructions by visiting: trex.com
THR-0626
Made with FlippingBook - Share PDF online