Install the Sump Basin Place the sump basin into the hole, ensuring it sits level. If necessary, add gravel around the basin to stabilize it. Make sure the basin's top is slightly below the level of the surrounding soil for proper drainage. Prepare the Discharge Pipe Next, you’ll need to drill a hole in the crawl space wall for the discharge pipe. This will direct the water away from your home. Measure carefully, and use a hole saw bit to drill the hole large enough to fit the PVC pipe. Connect the Sump Pump to the Basin Place the sump pump into the basin and attach it to the PVC piping. Use a check valve to ensure that water only flows out of the basin and doesn’t flow back in when the pump shuts off. Run the discharge pipe from the pump through the hole in the wall. Test the System Once everything is hooked up, test the pump by adding water to the basin. The sump pump should automatically kick on when the water level rises and pump it out of the crawl space. Make sure the discharge pipe directs the water away from your foundation. Seal and Final Touches If needed, use concrete or gravel to seal the area around the pipe, ensuring the water flows efficiently. Double-check that the system works properly, and inspect the crawl space for any other potential water entry points. Installing a sump pump in your crawl space may seem like a challenging task, but with the right tools and a little patience, it’s a manageable DIY project. By keeping your crawl space dry, you’ll protect your home from water damage and improve indoor air quality. Regular maintenance of the pump will ensure it continues to function effectively for years to come.
Aaron Bergeron 410-529-2029 Aaron.payneteam@gmail.com
Made with FlippingBook - PDF hosting