Catalog Rugged Digital Networks Solutions RJ Field USB field

Receptacle Connection side view

Main key

REMARK: as the receptacles are compounded (IP68 trans- versally sealing), the coding position has to be specified in the part number: A (standard), or B

USB insulation on the left

USB insulation on the right

Connection side view of the receptacle

Coding A

Coding B

Part number code Series USB Field TV

USBF TVX

2S

A

2

N

03

A

Shell Type 2S: square flange receptacle 7S: jam nut receptacle Coding: “A" (Standard) or "B" Back Terminations 2: rugged USB cable Shells Plating N: Nickel G: Olive drab cadmium plating USB cable length 03: 30 cm [11.81 inches] 05: 50 cm [19.68 inches] 10: 1 meter [39.37 inches] USB cable end A: Standard USB-A plug OPEN: Open cable (no connector)

CAPS for receptacles :

Plating

Cap for square flange receptacle

Cap for jam nut receptacle

Part number

USBFTVC2N USBFTVC2G USBFTVC2ZN

USBFTVC7N USBFTVC7G USBFTVC7ZN

Nickel

Olive drab cadmium

Black Zinc Nickel

Assembly instructions of the plug

1. Only if you need a full sealing (IP68): Install the white sticker around the plug, covering the 4 little holes of the overmolding 2. Insert the black O Ring around the front face of the USB A plug. This O Ring will ensure connection sealing 3. Insert the USB cordset into the metallic backshell 4. Insert the retention spacer laterally to the cable (this spacer is soft, in order to adapt to different shapes of overmolding) and slide the over- molding of the USB-A plug into this retention spacer 5. Insert the friction ring laterally to the cable 6. Choose the right coding (2 positions) and insert the USB-A plug into the protective plug. Note at this step, the main key is used for polarization.

1

2

3

4

Plug Connection side view

Main key

USB insulation on the left

USB insulation on the right

5

6

Coding A

Coding B

7. Screw the backshell on the plug body. A wrench can be necessary to fully tighten it, and the connection to the receptacle can help. IMPORTANT NOTE The connection sealing is not done by the black retention spacer (which is sloted), but by the front face ORing (fig.2)

7a

7b

IMPORTANT NOTE To remove the insert use the insert removal tool for plug.

P/N: USBF ODE

137

Made with FlippingBook - Online Brochure Maker