3. Make sure the gasket tape is in place on top of the oven inside the burner box frame.
2. Place the burner box within the frame on the top of the oven. There is a junction box with a terminal strip in it on the burner box. A wire must be run from this terminal strip to the oven control panel. This wire must be enclosed in conduit. Normally, there are three runs of conduit required for a given oven - – one for the motor leads, one for the thermocouples and flame rod, and one for the control wiring.
3.
Weld the burner box to the frame on top of the oven.
4. Connect the wires from the terminal strip box on the burner box to the terminal strip box on the top of the oven. All of the wires are numbered for easy reconnection.
5. On larger ovens, belt guards are shipped separately. Attach the belt guards using the included sheet metal screws.
6.
On the inside of the oven, the top air supply and return plenums should be secured to the sheet metal housing inside the burner box by sheet metal screws.
3.2
Exhaust Fan
The exhaust fan assembly includes the exhaust blower, motor and air seal. If the exhaust fan has been removed from the oven, the following steps are required for reassembly:
1.
Pick up the exhaust fan assembly using a forklift or overhead means.
2. Attach the exhaust kit to the top of the oven using the attached bolts and sheet metal screws. The exhaust kit is located over the large diameter hold in the top of the oven and the orientation will be obvious with the bolt and screw hold patterns.
3.
Reattach the electric wires from the kit to the adjacent junction box.
4.
Reconnect any air tubes that have been disconnected.
3.3
Remote Control Panel
Because of installation or handling limitations, a remote control panel is sometimes necessary. The remote control panel generally includes all controls that the operator must use on a daily basis, such as any temperature controls, start/stop switches, batch timer. The main control panel will contain the motor starters, the flame safety and the electrical service disconnect.
If the oven has a remotely mounted control panel, then the following steps are required for installation:
1.
Mount the control panel and electric disconnect at the desired location.
Made with FlippingBook - professional solution for displaying marketing and sales documents online