Section A
Floor Assembly
Step 1.
Floor Assembly W ith ¼” Floor Plate (optional).
(A)
Lay two sections of the floor plate down.
(B)
Square corner to corner and weld together.
Weld 2” long
approximately 10” apart. Continue until ba se is completely together per
dimensions on your set of drawings (see Dwg 1-B).
Note : Standard ovens DO NOT have ¼” floor. Step (A) is not required.
Step 2.
Floor Channel (All Dimensions Are On Customer Set of Drawings)
(A) Take chalk line and layout lines for O.D. (outside dimensions) & I.D.
(inside dimensions) of oven side walls and one end wall if oven is single
entry. If oven is double entry you only need side walls.
(B) Cut if necessary T-4 channel, lay between lines and attach channel the
full length of the oven. If it is a single entry you must 45 one end of each side
wall floor channel and both sides of end wall floor channel (see Dwg. 3-B).
(C) If oven has ¼” floor, you can weld floor channel to floor plate. If it has
no floor, you must drill holes in bottom of channel for anchor bolts. Anchor
with 3/8” floor anchors (not supplied) approximately 12” from each end and
then ever 6 ft. If heater box is floor mounted, you must cut T-4 or T-6 so you
leave an opening for it. You get opening width and location from customer
drawing (see Dwg. 3-C).
Made with FlippingBook - professional solution for displaying marketing and sales documents online