Section J
Installation of Door Opening Support Channel
Step 14.
Door Opening
(A) Get item number from customer drawings for the door opening support
channel. Make sure the door opening is square.
(B) Make marks 18” back from face of channel on the end wall (see Dwg.
14-B).
(C) Place vertical channel on marks setting on floor, this channel should
extend 2” above top of oven. Install two Tek Screws in channel to hold in
place. Install 3/8” floor anchors (not supplied) in angle at bottom of channel.
Install channel on the other side of the door in the same manner.
(D) Place top channel on over top, line up with two vertical channels and
weld in place.
(E)
Install the rest of the Tek Screws.
(F) In the kit there are four short channels 17” long (see customer
drawings for item numbers). These braces weld to face channel and support
channel (see Dwg. 14-B).
(G)
Install Tek Screws as required.
Made with FlippingBook - professional solution for displaying marketing and sales documents online