FLEET® Internal Comparison Sheet
Fleet® 100
KEEP OUT OF REACH OF CHILDREN
ACTIVE INGREDIENT Polyoxyalkylene Polymers.................................100.0%
CAUTION
NONPLANT FOOD INGREDIENT
Read entire label for additional precautionary statements and use directions. FOR PROFESSIONAL USE ONLY
FIRST AID If on Skin: Wash with soap and water. Consult a physician if any irritation persists If in Eyes: Rinse with clean water for 15 minutes. Remove contact lenses after the first 5 minutes and continue to rinse. Seek medical attention if irritation persists. If Ingested: Rinse mouth. Do NOT induce vomiting. Call 911 or a physician for treatment advice. Have the product label with you when calling a doctor or going for treatment.
PRECAUTIONS •
Avoid getting in eyes or on skin. Use safety glasses with side shields (or goggles) and water repellent, chemical resistant gloves when handling this product. Do not contaminate water during application or when cleaning equipment. IN CASE OF SPILL OR MEDICAL EMERGENCY, CONTACT CHEMTREC 1-800-424-9300. •
NET CONTENTS:
250 gallons (946 liters)
30 gallons (113.52 liters)
2.5 gallons (9.46 liters) Weight per gallon: 8.75 lbs. @ 68°F
# FLEET100-2.5 #FLEET100-30 #FLEET100-250 09/17
Harrell’s, LLC Post Office Box 807 | Lakeland, FL 33802 | (800) 282-8007 | Harrells.com
FREQUENTLY ASKED QUESTIONS: - Must Fleet® be irrigated in immediately after application?
o No, but Fleet® should be irrigated to the desired soil depth within 12 hours of application.
- Will Fleet® cause phytotoxicity if not irrigated in immediately? o Fleet® applied alone does not typically cause phytotoxicity. Fleet® in combination with other tank mix partners may cause phytotoxicity, especially when sprayed under very dry or hot conditions. Follow manufacturer label instructions for all products and test all tank mixtures in a small area prior to wide-scale application. - What is the ideal application volume for Fleet® and how much irrigation is sufficient after application? o Fleet® should be applied in 1 to 2 gallons of water per 1,000 square feet. Fleet® application should be followed by 0.5 to 1 inch of irrigation, or adequate irrigation to move Fleet® through the soil profile to the desired soil depth. - Can Fleet® be lightly irrigated immediately following application then heavily irrigated the following night? o Yes; however, Fleet® may become “locked” into the top portion of the soil profile following a light irrigation. A second Fleet® application followed immediately by a deep irrigation cycle or rainfall event can overcome this effect. - What is the correlation between organic matter percentage and Fleet® performance? o There is no correlation. However, compared to low organic matter soils, root zones high in organic matter require more irrigation following application in order to distribute Fleet® evenly throughout the root zone to the desired soil depth. - Can Fleet® be applied in tank mix with other products such as contact fungicides and Primo Maxx? o It is recommended that Fleet® be applied alone or with soil-directed products, e.g., EarthMAX, Max Calcium, Potassium Silicate, etc. - What happens if Fleet® is tank-mixed with another wetting agent? o Field experience has demonstrated that combination of Fleet® with another wetting agent will increase soil water holding capacity relative to an application of Fleet® alone. - Can Fleet® be applied prior to a predicted rainstorm? o Yes, a rain event can effectively distribute Fleet® throughout the root zone if total rainfall volume is adequate to move Fleet® to the desired soil depth. - Can too much irrigation be applied following Fleet® application? o Irrigation cycles typical to golf course management are not sufficient to flush Fleet® through the root zone. A severe rain event could move the chemistry past the desired depth in soils with high hydraulic conductivity.
Made with FlippingBook - Online Brochure Maker