TSUBAKI BACKSTOP CAM CLUTCH PRODUCTS TSUBAKI CAM CLUTCH
TSUBAKI INDEXING,
P. 82
P. 80
P. 90
P. 56
MIUS MIUS Series is for mid-speed indexing applications up to 300 cycles a minute. Bore Range: 0.500" to 6.250" (12.7 to 160 mm) Torque Range: 280 to 27,290 lbs. ft. COMPETITOR MODELS: Formsprag HPI Morse MI Marland RMS
P. 86
CA CA line of backstops are an integral part of the reducer. The unique non-rollover cam design is key and prevents damage to the gears, shafts and drive train. This is a drop- in replacement for Dodge ® reducers. Bore Range: 0.738" to 1.750" (18.75 to 44.45 mm)
BS & BS-F BS Series is designed for lower speed conveyor applications. The unique non-rollover cam design provides higher torque capacity, assuring full engagement. Bore Range: 0.750" to 5.315" (20 to 135 mm) Torque Range: 217 to 11,580 lbs. ft. BS-F Series is designed for simple, drop-in installations to all major competitive backstop products. Uses unique seal design for maximum life, minimal maintenance. Bore Range: 2.360" to 18.310" (60 to 465 mm) Torque Range: 4,980 to 722,000 lbs. ft.
BSEU BSEU Cam Clutches are a European variation popular on many bucket elevators in North and South America. Bore Range: 0.787" to 3.543" (20 to 90 mm) Torque Range: 159 to 3,467 lbs. ft. COMPETITOR MODELS: Formsprag RSBW
Torque Range: 45 to 901 lbs. ft. COMPETITOR MODELS: Dodge 24 Series
Morse CR/BW Stieber RSBW
P. 42
P. 78
P. 74
P. 67
TSS TSS Series clutch is designed for press fit installation. Outside dimensions are the same as series 62 ball bearings. Bore Range:
BR-HT BR-HT Series is designed for backstop applications where high-speed overrunning is required. Lift off cam design assures minimal heat generation and longest life. Bore Range: 0.787" to 5.118" (20 to 320 mm) Torque Range: 77 to 269,950 lbs. ft. COMPETITOR MODELS: Formsprag RSCI; Ringspann FXM
BREU BREU Series is designed for backstop applications where bearing support and modular construction is desirable. Bore Range: 1.181" to 5.906" (30 to 150 mm) Torque Range: 447 to 25,009 lbs. ft. COMPETITOR MODELS: Formsprag RIZ; Stieber RIZ
BRUS BRUS series of high-speed external backstops utilize non- rollover and lift-off design cams. This is a drop-in replacement for Falk ® BIF backstops. Bore Range: 1.125" to 3.750" (28.58 to 95.25 mm) Torque Range: 700 to 4,420 lbs. ft.
0.314" to 2.362" (8 mm to 60 mm) Torque Range:
4 to 479 lb.ft. (6 to 649 Nm) COMPETITOR MODELS: Formsprag AS Morse NSS Ringspann FCN
COMPETITOR MODELS: Falk BIF; Formsprag FHB; Ringspann FRXF
Dodge ® is a registred trademark of Baldor Electric Company Corporation. Falk ® is a registered trademark of Rexnord Industries, LLC. 2
Made with FlippingBook Digital Proposal Creator