LB1000F LOADING BENCH INSTRUCTIONS
0F LOADING BENCH OPERATING
Rev 1.0 (9/15/2025)
What's Included: Loading Bench and hardw Accessories sold separately: Mountz torque analyzer, BMX torque sensor and
ware for mounting the BMX torque sensor. Mountz torque analyzer, BMX torque sensor and cable for BMX torque sensor. cable for BMX torque sensor.
Reaction Position Horizontally: 4.87” to 77” from the center of the turn Vertically: 2.25” to 10” from the turn-table base Ratio (1:663)
” from the center of the turn-table table base
Mounting the LB1000F The LB1000F can be operated on a stable, level workbench. bench can be attached to the work table. To attach to a workbench, use 3/8" the underside of the workbench and thread into the can be operated on a stable, level workbench. For additional security, the loading bench can be attached to the work table. To attach to a workbench, use 3/8"-16 fasteners from the underside of the workbench and thread into the thread inserts in the footpads.
Keep flush with
bench edge
Torque Sensor Set-up Attach the BMX to the the rotating baseplate usin Attach the BMX to the the rotating baseplate using the correct hardware provided.
Base Plate
Make sure the wrench is within the torque range of the BMX model. If the tool is under the torque range, then the accuracy may not be reliable. If the tool is over the torque range, then you may overtorque the BMX and damage the sensor.
Reaction Bars
Attach the sensor cable (sold separately) for connecting the BMX with a Mountz torque analyzer with an external sensor connection cable (sold separately) for connecting the BMX with a Mountz with an external sensor connection.
Once the BMX is connected with the torque analyzer, follow the instructions in the torque analyzer manual for accessing external transducers the torque analyzer manual for accessing external transducers.
Calibrating & Testing Torque Wrenches Wrenches
Hand Wheel
Place the wrench’s drive into the BMX’s female square drive. bars to secure the grip of the wrench handle. Place the wrench’s drive into the BMX’s female square drive. Adjust the position of the reaction bar by sliding along the sliding bars to secure the grip of the wrench handle. Use the bottom and top locking clamps to secure the wrench handle so its level. wheel clockwise. This will rotate the sensor until the wrench's pre-adjusted torque is reached with a click. Record the torque reading from the analyzer and compare against the pre-adjusted torque on the wrench. the load by turning the wheel in the opposite direction. Adjust the position of the reaction bar by sliding along the sliding Use the bottom and top locking clamps to secure the wrench handle so its level. adjusted torque is reached with a click. adjusted torque on the wrench. Once the desired Turn the hand wheel clockwise. This will rotate the sensor until the wrench's pre Record the torque reading from the analyzer and compare against the pre torque is reached, back off the load by turning the wheel in the opposite direction.
SILICON VALLEY HEADQUARTERS 1080 North 11th Street, San Jose, CA 95112 | Phone: (408) 292 1080 North 11th Street, San Jose, CA 95112 | Phone: (408) 292-2214 | Fax: (408) 292-2733 | mountztorque.com
1
Made with FlippingBook Annual report maker