Die Cast
®
6
For Die Makers and Die Casters
Three Ways to Increase Your Productivity
® 1. USE AN A OR B-SERIES MOLD BASES. With the appropriate sprue spreader and bushing installed, or a shot-sleeve hole bored to your specifications, A or B-Series Bases are readily adapted for zinc and aluminum die casting. See page 7. 2. USE STANDARD DIE BLOCKS, PLATES AND OTHER COMPONENTS. With our wide range of plates, die blocks, retainer sets, ejector pins and other die components you can design a complete die buildup to suit your specific needs and still retain the full benefits of DME quality, standardization and service. See page 8. 3. USE STANDARD UNIT DIES. For both long and short runs, for zinc or aluminum we offer both single and double unit dies in a variety of sizes. Replacement units are available in DME No. 2, No. 3 and No. 5 Steel. See pages 10-19.
DIE BLOCKS, PLATES AND COMPONENTS
STANDARD UNIT DIES
SPRUE SPREADERS AND BUSHINGS..
Replacement Sprue Spreaders (previous style)................. 20.
Sprue and Runner Spreaders & Bushings (for Zinc)....20-28. Die Clamps................................................................................. 29
DIE CLAMPS
Information available on Standard Unit Die Holders and Replacement Units
To assist designers in saving time on laying out cavities and cores within DME Standard Unit Dies, CAD Data can be downloaded from www.dme.net. The general dimensions of our complete line of Standard Unit Dies for zinc and aluminum are shown on page 19.
AHP MERKLE ® CYLINDERS
SLIDE SPRAYS
U.S. 800-626-6653 • Canada 800-387-6600 • DME.net • store.DME.net
Made with FlippingBook - professional solution for displaying marketing and sales documents online