Die Cast
®
7
Die Cast Die Assemblies
For Zinc and Aluminum Die Casting The economy of using standard mold assemblies for zinc and aluminum die casting has been well established over the years. Standard "A" and "B" Series Mold Bases are both widely used. For zinc die casting, a Standard Water-cooled Sprue Spreader and Bushing are installed in place of the sprue bushing and sprue puller pin used in plastics molds. For aluminum, a shot-sleeve hole is bored to customer specifications. ALUMINUM DIE CAST DIES When ordering, please specify: 1. Item Number of "A" or "B" Series Mold Base. 2. No. 2 or No. 3 Steel (No. 5 Steel available on spe- cial order). Provide a dimensioned drawing with diameter and loca- tion of shot-sleeve hole. Prices will be quoted per your drawing. ZINC DIE CAST DIES When ordering, please specify: 1. Item Number of "A" or "B" Series Mold Base. 2. No. 2 or No. 3 Steel (No. 5 Steel available on spe- cial order). 3. Item numbers of Spreader and Bushing required. 4. If Spreader location is off-center, please supply a dimensioned drawing. See pages 21-28 for Spreaders and Bushings. Installation costs for Spreader and Bushing will be quoted per your drawing or specifications. FOR ZINC OR ALUMINUM DIES Prices can also be quoted per your drawing for the fol- lowing additional work: • cavity and core insert pockets • core slide pockets • shot plugs (furnish and install) • runners and kicker pads • knock-out holes
STANDARD "A" SERIES MOLD BASE WITH STANDARD WATER-COOLED SPRUE SPREADER AND BUSHING INSTALLED FOR ZINC DIE CASTING.
• ejector pin installation • pipe clearance holes • water lines and eye bolt holes • special clamp slots
STANDARD "B" SERIES MOLD BASE WITH A SHOT-SLEEVE HOLE FOR ALUMINUM DIE CASTING.
Made with FlippingBook - professional solution for displaying marketing and sales documents online