TREX ® DECKING COLOR-MATCH COMPOSITE SCREW Installation Instructions
IMPORTANT NOTES: » Not recommended for use in salt environments.
» Not for use with sleeper systems that are less than 2” thick. » Always follow deck board manufacturer’s installation guidelines.
General Installation Recommendations: • Always use two screws per joist or stair stringer. • At board ends on the deck's edge, install screws placed perpendicularly at the recommended distance, at minimum of 1" from the board end and edge, without splitting the board.
PARTS & TOOLS NEEDED
2 1/2"
HEXSTIX® HS-20 Drive Bit
Trex Hideaway® Color-Match Composite Screw
Installation Instructions:
• S crews are designed to be installed flush with decking surface.
3
1
• F or best results pre-drill through deck board only, using 1/8” drill bit. When installing close to the end of the board pre-drilling is required.
DO NOT countersink screws.
2
• F or best results use an 18V or higher cordless drill and the included HEXSTIX® driver bit, install fasteners at a 90° angle (perpendicular to the board). Always drive screw in one smooth, continuous motion.
Note: Never use Torx® ttap® bits in a HexStix® screw.
Have Questions? 1–800–BUY–TREX
NOTE: Construction methods are always improving. Please ensure you have the most up-to-date installation instructions by visiting: trex.com NOTE: Construction methods are always improving. Please ensure you have the most up-to-date installation instructions by visiting: trex.com
THR-0220 DCM-0323
Page 1Made with FlippingBook - Share PDF online