GSX MILL 2 Flute Endmills Sharp Edge GSX 20000S-4D Type
Recommended Cutting Conditions 1. For stable machining performance use rigid, high-precision machines and holders. 2. Use air blow when dry machining. 3. Use wet machining for stainless steel, heat-resistant alloy, and titanium alloy applications. 4. If chatter is a problem, reduce the spindle speed and feed rate indicated in the table below by the same ratio, or reduce the depth of cut. 5. This series is not recommended for groove milling. 6. If the machine cannot achieve the recommended spindle speed, please use the maximum spindle speed available.
a e
DC
Side Milling
I
Carbon Steel SC (150 to 250HB)
Alloy Steel SCM (25 to 35HRC)
Tempered Steel, Hardened Steel NAK , HPM (35 to 45HRC)
Work Material Cutting Conditions
Steel for Structure SS
Cast Iron FC
Hardened Steel (45 to 55HRC)
Stainless Steel SUS304,SUS316
Heat-Resistant Alloy Titanium Alloy
Spindle Speed (min -1 )
Feed Rate (mm/min)
Spindle Speed (min -1 )
Feed Rate (mm/min)
Spindle Speed (min -1 )
Feed Rate (mm/min)
Spindle Speed (min -1 )
Feed Rate (mm/min)
Spindle Speed (min -1 )
Feed Rate (mm/min)
Spindle Speed (min -1 )
Feed Rate (mm/min)
Spindle Speed (min -1 )
Feed Rate (mm/min)
Spindle Speed (min -1 )
Feed Rate (mm/min)
DC (mm)
7,600 3,850 1,900 1,250
110 150 200 250
7,600 3,850 1,900 1,250
110 150 200 250
6,000 2,950 1,450
80
5,500 2,750 1,350
40 60 80 90 90 95 85 80 70 55
3,800 1,900 1,000
25 30 50 60 60 60 60 45 35 30
4,600 2,300 1,150
35 40 55 60 60 60 60 50 40 30
3,800 1,950 1,000
20 30 35 40 40 40 40 35 30 25
1.0 2.0 4.0 6.0 8.0
7,600 3,850 1,900 1,250
110 150 200 250
100 130
970 140 700 140 190 130 470 130 370 120 300 100
860 670 560 420 340 260 200
640 500 380 330 250 190 150
740 560 460 370 280 220 170
640 490 380 320 250 190 150
930 220 770 210 650 200 450 170 360 140 190 120
930 220 770 210 650 200 450 170 360 140 190 120
930 220 770 210 650 200 450 170 360 140 190 120
10.0 12.0 16.0 20.0 25.0
230
80
2.5DC
2.0DC 0.01DC
a p a e
Standard Depth of Cut
Below ø3 : 0.02DC, Above ø3 : 0.05DC
I 53
Made with FlippingBook flipbook maker