GSX MILL 4 Flute Endmills Sharp Edge GSX 40000S-4D Type
Recommended Cutting Conditions 1. For stable machining performance use rigid, high-precision machines and holders. 2. Use air blow when dry machining.
3. Use wet machining for stainless steel, heat-resistant alloy, and titanium alloy applications. 4. In some cases, chattering may occur in early stages of milling but will cease after 2m of cutting. 5. If chatter is a problem, reduce the spindle speed and feed rate indicated in the table below by the same ratio, or reduce the depth of cut. 6. If the machine cannot achieve the recommended spindle speed, please use the maximum spindle speed available.
a e
DC
Side Milling
I
Carbon Steel SC (150 to 250HB)
Alloy Steel SCM (25 to 35HRC)
Tempered Steel, Hardened Steel NAK , HPM (35 to 45HRC)
Work Material Cutting Conditions
Steel for Structure SS
Cast Iron FC
Hardened Steel (45 to 55HRC)
Stainless Steel SUS304,SUS316
Heat-Resistant Alloy Titanium Alloy
Spindle Speed (min -1 )
Feed Rate (mm/min)
Spindle Speed (min -1 )
Feed Rate (mm/min)
Spindle Speed (min -1 )
Feed Rate (mm/min)
Spindle Speed (min -1 )
Feed Rate (mm/min)
Spindle Speed (min -1 )
Feed Rate (mm/min)
Spindle Speed (min -1 )
Feed Rate (mm/min)
Spindle Speed (min -1 )
Feed Rate (mm/min)
Spindle Speed (min -1 )
Feed Rate (mm/min)
DC (mm)
7,950 4,050 1,950 1,350
7,950 4,050 1,950 1,350
7,950 4,050 1,950 1,350
6,250 3,100 1,650 1,000
5,750 2,850 1,400
4,000 2,050
4,850 2,400 1,200
4,000 2,050 1,050
1.0 2.0 4.0 6.0 8.0
120 120 170 130
120 120 170 130
120 120 170 130
70 90
50 70 90
35 50 35 55 55 50 55 50 45 35
35 50 45 40 40 40 40 40 40 30
35 35 30 30 30 30 30 30 30 25
100 140
710 700 520 360 350 260 210 170
930 120 720 120 570 100 460 100
800 560 490 400 280 240 190
700 490 410 350 270 210 170
970 190 770 180 640 170 460 140 390 130 310 100
970 190 770 180 640 170 460 140 390 130 310 100
970 190 770 180 640 170 460 140 390 130 310 100
740 140 630 120 500 120 370 100
10.0 12.0 16.0 20.0 25.0
360 280 220
90 70 55
310 250
90 70
2.5DC
2.0DC 0.01DC
a p
Standard Depth of Cut
a e Below ø3 : 0.02DC , Above ø3 to Below ø8 : 0.05DC, Above ø8 : 0.07DC
I 71
Made with FlippingBook flipbook maker