Indexable Insert Drills WDX Series Insert Selection Guide - Wide Selection of Inserts for WDX Series 5 Grades 4 Types of Chipbreakers
11 Combinations are possible!
Grade
High
Part Material
ACM300 ACK300
DL1500
ACP100
ACP300
M
ACK300
DL1500
ACP100
ACP300
ACM300
H
Steel (High-Speed Drilling) P
L P K G P K H P K
H P G P M L P
L P K G P K H K
G
P Steel
(General Drilling)
G N
L
Stainless Steel M Cast Iron (High-Speed Drilling) K Cast Iron (General Drilling) K Non-Ferrous Metals N
.0019 .0039 .0059 .0079 .0099 Feed Rate f (IPR)
M
M
J
G ACP100 General- Purpose For Low Feed with Chip Evacuation L ACP100
Steel
Steel
Steel
Strong Edged
For Low Feed with Chip Evacuation
· For insufcient cutting edge strength due to drilling of hardened steel (heat treated) H ACP300 · For drilling with interruptions (entry/through) due to slanted entry, reduce the feed rate in the interrupted area (around f = 0.0019 IPR)
· For drilling various types of Steel L ACP300 · High speed and low feed is recommended if there are issues with chip control · Decrease the feed if vibration occurs due to burnt chips
· For drilling of general steel and alloy steel, when prone to signicantly large ank wear
Steel
P
· For low-feed conditions
Insufcient wear resistance
Improved chip control (low carbon steel, etc.)
Initial chipping measures (interruption, high hardness, etc.)
Steel
Steel
Steel
General- Purpose
For stainless steel drilling
ACK300 For cast iron drilling ACP300 For general steel & alloy steel drilling DL1500 For non-ferrous metal drilling
Stainless Steel ACM300
Steel
Steel
M Stainless Steel
G
Cast Iron
P M K N
Cast Iron
Non-Ferrous
Insufcient wear resistance (high-speed drilling)
Lack of chip evacuation (extension)
Initial chipping measures (interruption, high feed, etc.)
Cast Iron
Cast Iron
Cast Iron
Cast Iron
G ACP300 General- Purpose · When chips extend and clog
Strong Edged
General- purpose
G ACP100 · When heavy ank wear occurs in cast iron drilling · To limit wear in high-speed, low to medium feed conditions
H ACK300 · When interrupted drilling is performed due to slanted entry, etc. as with steel drilling · For insufcient cutting edge strength due to high-feed drilling
M K
*ACP100 is the first recommendation for steel with a hardness of 200HB or greater, or for high-speed drilling of steel.
J124
Made with FlippingBook flipbook maker