S9074-AQ-GIB-010/248 Rev 1
Discard Reduced section tensile
4
HAZ Charpy impact - weld Side bend Charpy impact - weld
5
5
All weld tensile
5 4
Charpy impact - weld
Side bend HAZ
All weld tensile
5 4
Charpy impact - weld HAZ Charpy impact - weld Side bend
5
Reduced section tensile
4
Discard
T
NOTES: 1. Joint design (see 4-4.1.3). 2. Test assembly material (see 4-4.1.1). 3. Test assembly size (see 4-4.1.2). 4. Tensile specimen requirements are specified in footnote 6 of table 7-7.
5. When HAZ toughness testing is required, a straight wall joint design is preferred. Material for specimens shall be removed as indicated. Base metal specimens shall be removed from the same side of the joint as the HAZ specimens and located along the same longitudinal axis as each HAZ specimen or immediately below or above its related HAZ specimen. See figure 7-24 for preparation of HAZ CVN impact specimens.
Figure 7-2. Typical Welding Procedure Qualification Test Plate and Recommended Locations for Removal of Test Specimens
.
7-71
Made with FlippingBook - Share PDF online